A.
Check dimensions of area where ROLLARAMP is to be installed.
B. The clearance between the body long sills and hanger bolts must
be a minimum of 27-3/8".
C. Minimum depth required between truck chassis and bottom of body
cross-members is 5-1/2".
Step 2
A.
Position ROLLARAMP in truck opening between body long sills.
B. Move the assembly until the ramp handles are a recommended distance
of ½" inboard of rear apron. This prevents accidental
damage to the ROLLARAMP handles when backing up to a loading dock,
etc.
Step 3
Secure
the ROLLARAMP FRAME assembly to the body cross-members by welding
short steel hanger angles starting at forward end and at intervals
of approximately four (4) feet. IMPORTANT: Shield ramp from weld
spatter.
Step 4
A.
Cut two notches or cutouts 1-1/4" wide as indicated in rear
apron for ramp hooks.
B. Notches should be spaced, center to center, 23".
C. Reinforce cutouts with 1/8" x 1" x 3" steel
bar stock to support hooks.
Step 5 FINAL CHECK
A.
Fully extend ramp, check anti-theft stop function.
B. Check the fit of ramp hooks into cutouts on rear apron. (See
Step 4 for dimension.)
C. Return ramp to latch position.
D. Attach the "Operating Instructions" label to a clean
and prominent location on the back of the truck body.
